Danby DDR050EBWDB Dehumidifier Manual

The Danby DDR050EBWDB is a 50-pint dehumidifier designed for residential use, featuring electronic controls, a continuous drain option, auto-defrost, a built-in humidistat, a 24-hour timer, a washable air filter, and a full-bucket alert with auto-shutoff. It operates on 115V/60Hz power and is suitable for areas up to 3000 sq. ft. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Installation & Placement 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Operation Modes 7. Maintenance & Cleaning 8. Drainage Options 9. Safety Features 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Electronic control panel, removable water bucket, continuous drain port, washable air filter, casters for mobility, and built-in handle.

Feature	Description
Electronic Controls	Digital display with touch buttons for settings
Humidistat	Automatically maintains desired humidity level
24-Hour Timer	Program on/off cycles
Continuous Drain Option	Garden hose connection for unattended operation
Auto-Defrost	Prevents coil freezing in low temperatures
Full-Bucket Alert	Indicator light and auto-shutoff when bucket is full
Washable Air Filter	Captures airborne particles; can be cleaned
Casters	Easy mobility between rooms
Power Cord Storage	Compartment for neat storage
ENERGY STAR® Certified	Energy efficient operation

Installation & Placement

Unpack and inspect contents. Place on a level, stable floor.

Choose location: Place in center of room, away from walls/furniture (min 12-18 inches clearance).
Ensure proper airflow: Do not block air intake or exhaust grilles.
Check environment: Operate in temperatures between 41°F (5°C) and 95°F (35°C).
Plug into dedicated 115V outlet: Ensure outlet is grounded and not shared with high-draw appliances.

WARNING! Do not use in confined spaces or near heat sources. Ensure unit is upright before operating.

First-Time Setup

Power on dehumidifier; configure initial settings.

Install air filter: Ensure washable filter is correctly seated in the front grille.
Set humidity level: Press HUMIDITY button to select desired RH% (40-60% recommended).
Set fan speed: Choose LOW or HIGH via FAN button.
Set timer (optional): Use TIMER button to program automatic start/stop.
Select drainage: Choose between bucket collection or connect hose for continuous drain.

CAUTION! Handle water bucket with care to avoid spills. Unit must be upright for 24 hours after transport before first use.

Specifications

Model: DDR050EBWDB
Dehumidification Capacity: 50 pints per day (at 60°F, 60% RH)
Coverage Area: Up to 3000 sq. ft.
Power Supply: 115V / 60Hz
Amperage: 5.0A
Water Bucket Capacity: 1.6 gallons (6 liters)
Operating Temperature Range: 41°F to 95°F (5°C to 35°C)
Noise Level: ≤ 51 dB
Dimensions (HxWxD): 23.4" x 15.0" x 11.2"
Weight: 40.8 lbs
Refrigerant: R410A

Controls and Settings

Access settings via electronic control panel. Display shows current humidity, set point, timer, and alerts.

Control Panel Buttons: POWER, HUMIDITY (up/down), FAN SPEED (LOW/HIGH), TIMER (set hours), MODE (Continuous/Auto).

Humidity Control: Set between 35% and 85% RH. Fan Speed: LOW for quiet operation, HIGH for maximum moisture removal. Timer: Program from 1 to 24 hours. Mode: CONTINUOUS runs non-stop; AUTO uses humidistat to cycle on/off. Alerts: Full bucket indicator (red light), filter check reminder (icon).

Operation Modes

Auto Mode: Unit runs until set humidity is reached, then cycles off/on to maintain it. Continuous Mode: Runs constantly regardless of humidity. Laundry Mode: Boosts fan speed for faster drying in laundry areas.

Press POWER to turn on.
Select MODE (Auto or Continuous).
Set desired humidity with HUMIDITY buttons.
Select fan speed with FAN button.
Monitor water collection: Empty bucket or use continuous drain.

Tip: Use Auto mode for energy savings. Close windows and doors for best performance.

Maintenance & Cleaning

Unplug unit before any maintenance.

Clean air filter: Remove every 2 weeks, rinse with warm water, dry completely before reinstalling.
Empty water bucket: Remove, pour out water, clean with mild detergent, dry before replacing.
Clean exterior: Wipe with soft, damp cloth. Do not use abrasive cleaners.
End-of-season storage: Empty bucket, clean filter, coil, and interior. Wrap cord and store upright in dry place.

WARNING! Do not operate without air filter. Never immerse unit in water.

Drainage Options

Bucket Drainage: Standard method; monitor and empty when full. Continuous Drainage: Connect 5/8" ID garden hose (not included) to drain port at back.

For continuous drain: Place unit near floor drain or sink.
Remove bucket and attach hose to drain port securely.
Ensure hose runs downward without kinks.
Select CONTINUOUS mode; unit will drain automatically.

CAUTION! Ensure hose connection is tight to prevent leaks. Do not lift unit while hose is attached.

Safety Features

Auto Shutoff: Turns off when bucket is full or improperly seated. Tip-Over Switch: Stops operation if unit is tilted. Overload Protection: Protects compressor from electrical surges. Auto-Defrost: Prevents ice buildup on coils in cool temperatures.

Regulatory Information

FCC Compliance: This device complies with Part 15 of FCC Rules. UL Listed: Meets safety standards. EPA Certified: ENERGY STAR® qualified. For support, visit www.danby.com or contact 1-800-263-2629. This product contains refrigerant; dispose of according to local regulations.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Unit not turning on	No power / full bucket	Check outlet; reset GFCI; ensure bucket is empty and properly seated.
Not removing moisture	Filter dirty / doors open	Clean air filter; ensure room is sealed; check that humidity set point is below current RH.
Water leaking	Bucket misaligned / hose leak	Remove and reinsert bucket; check hose connection; ensure unit is level.
Loud noise	Loose parts / fan obstruction	Ensure unit is on solid floor; check for objects near fan; tighten external panels.
Frost on coils	Low room temperature	Auto-defrost will activate; move to warmer area if below 41°F (5°C).
Display not working	Power issue	Unplug for 1 minute, then restart; check circuit breaker.

Reset: Unplug for 10 minutes to reset electronic controls.

Service: 1-800-263-2629; www.danby.com