The Danby DDR060BECWDB is a 60-pint energy-efficient dehumidifier designed for residential use. It features automatic humidity control, a continuous drain option, a full tank alert with auto-shutoff, a washable air filter, a digital display, a 24-hour timer, and quiet operation. Ideal for basements, living areas, and other spaces up to 3000 sq. ft. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.
Key components: Digital Control Panel, Water Tank, Continuous Drain Hose Port, Washable Air Filter, Casters for Mobility, Handle for Transport.
| Feature | Description |
|---|---|
| Digital Control Panel | For setting humidity level, timer, and viewing status |
| 60-Pint Capacity | Removes up to 60 pints per day (at 80°F, 60% RH) |
| Automatic Humidity Control | Maintains set humidity level (30%-90% RH) |
| Continuous Drain Option | Gravity drain port for hose connection |
| Full Tank Alert & Auto-Shutoff | Stops operation and lights indicator when tank is full |
| Washable Air Filter | Captures airborne particles; can be cleaned |
| 24-Hour Timer | Program on/off cycles |
| Quiet Operation | Low noise design for living spaces |
| Casters & Handle | For easy mobility and placement |
| Energy Efficient | ENERGY STAR® certified |
Unpack and inspect contents. Place on a level, stable surface.
WARNING! Do not place near heat sources or in direct sunlight. Ensure the unit is upright for at least 24 hours before first use if transported on its side.
Plug in the dehumidifier; the control panel will illuminate.
CAUTION! Handle the water tank with care. Do not operate without the air filter installed.
Access all functions via the Digital Control Panel on top of the unit.
Control Panel: POWER Button, HUMIDITY Up/Down Buttons, FAN Speed (High/Low), TIMER Button, FILTER Alert Indicator, FULL TANK Indicator.
Modes: AUTO (maintains set humidity), CONTINUOUS (runs constantly). Fan Speed: Adjust between High (faster dehumidification) and Low (quieter operation). Timer: Set from 1 to 24 hours for automatic shutdown or startup. Alerts: FILTER light indicates when to clean the air filter; FULL TANK light illuminates when bucket needs emptying.
Auto Mode: Unit cycles on/off to maintain the set humidity level. Continuous Mode: Runs constantly until turned off or tank is full.
Tip: Use Continuous mode for rapid moisture removal after flooding or in very damp conditions.
Unplug the unit before any maintenance.
WARNING! Never immerse the unit in water. Do not operate without the filter.
If storing the dehumidifier for more than a few weeks:
CAUTION! Store in an area where temperatures will not drop below freezing.
This appliance complies with Part 15 of the FCC Rules. Operation is subject to the condition that it does not cause harmful interference. This product is ETL listed to UL standard 474. Copyright © Danby Products Inc. For support, visit www.danby.com or contact customer service at 1-800-263-2629.
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Unit does not start | No power / Full tank | Ensure plug is secure; outlet has power; empty water tank. |
| Little or no water collection | Low humidity / Cold room | Room humidity may already be low; unit runs less. Not effective below 65°F. |
| Unit runs but stops quickly | Set humidity too high | Lower the target humidity setting on control panel. |
| FILTER light is on | Dirty air filter | Clean the washable air filter as per instructions. |
| Loud or unusual noise | Uneven surface / Loose parts | Place unit on level floor; ensure water tank and filter are properly seated. |
| Water leakage | Tank not seated / Drain hose issue | Remove and reinsert tank; check drain hose for kinks or blockages. |
Reset: Unplug for 60 seconds, then plug back in.
Service: 1-800-263-2629; www.danby.com