Danby Diplomat DDR1506 Dehumidifier Manual

The Danby Diplomat DDR1506 is a 15-pint capacity dehumidifier designed for residential use in rooms up to 1500 sq. ft. It features automatic humidistat control, continuous drain option, auto-restart after power interruption, washable air filter, low temperature operation, full tank alert with auto-shutoff, and caster wheels for mobility. Below are key sections for safety, features, installation, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Dehumidifier unit, Water collection bucket, Washable air filter, Power cord, Continuous drain hose (optional), User manual.

Installation & Placement

Unpack and inspect contents. Place on level, stable surface.

1. Choose location: Place in center of room or area with high humidity, away from walls/furniture (minimum 12 inches clearance).
2. Check airflow: Ensure air intake and exhaust vents are unobstructed.
3. Install bucket: Insert water collection bucket securely until it clicks.
4. Connect to power: Plug into dedicated 115V outlet; avoid extension cords.
5. For continuous drain: Attach ½” ID hose to drain port (hose not included).

WARNING! Do not place in tight enclosures or near heat sources. Ensure proper ventilation.

First-Time Setup

Power on dehumidifier; follow initial setup steps.

1. Set humidity level: Press HUMIDITY button to set desired RH% (40-60% recommended).
2. Select mode: Choose between CONTINUOUS or AUTO (humidistat-controlled) operation.
3. Set timer: Use TIMER button for automatic on/off scheduling if needed.
4. Check filter: Ensure washable filter is clean and properly installed.
5. Test operation: Allow unit to run for 24 hours to assess performance.

CAUTION! Handle with care when moving; use caster wheels. Keep unit upright.

Specifications

• Model: Danby Diplomat DDR1506.
• Capacity: 15 pints per day (at 60°F/60% RH).
• Coverage: Up to 1500 sq. ft. in residential settings.
• Power: 115V, 60Hz, 2.5A.
• Water Tank: 1.8 gallon (6.8 L) capacity with handle.
• Noise Level: ≤ 51 dB.
• Operating Temp: 41°F to 95°F (5°C to 35°C).
• Dimensions: 15.4" W × 11.4" D × 19.9" H.
• Weight: 30.9 lbs.
• Refrigerant: R-410A.

Controls and Settings

Control Panel: POWER, MODE, HUMIDITY, FAN SPEED, TIMER, FILTER RESET. Digital Display: Current humidity, set point, timer, filter alert, full tank indicator.

Humidity Control: Adjust set point from 35% to 85% RH. Modes: AUTO (humidistat control), CONTINUOUS (constant run), DRY (for laundry rooms). Fan Speed: HIGH or LOW settings. Timer: Program on/off from 1 to 24 hours. Filter Alert: LED indicates when filter needs cleaning.

Operation Modes

Auto Mode: Unit cycles on/off based on humidistat setting. Continuous Mode: Runs constantly until turned off or tank is full. Laundry Mode: Higher fan speed for rapid drying in damp areas.

1. Press POWER to turn on.
2. Select MODE to choose Auto, Continuous, or Laundry.
3. Adjust HUMIDITY set point as desired.
4. Select FAN SPEED (High for faster dehumidification).
5. Monitor display for current humidity and alerts.

Tip: For energy savings, use Auto mode with set point at 50% RH.

Maintenance & Cleaning

Regular maintenance ensures optimal performance and longevity.

1. Clean air filter: Remove, wash with mild detergent every 2 weeks, dry completely before reinstalling.
2. Empty water bucket: When full tank light illuminates, remove bucket, empty, and replace securely.
3. Clean exterior: Wipe with soft, damp cloth; do not use abrasive cleaners.
4. Check drain hose: If using continuous drain, ensure hose is clear and properly connected.
5. Reset filter indicator: After cleaning filter, press and hold FILTER RESET for 3 seconds.

WARNING! Always unplug unit before cleaning. Do not immerse in water.

Draining Options

Bucket Drain: Manual emptying when full tank light comes on. Continuous Drain: Connect ½" ID hose to rear drain port for automatic draining to floor drain or sink.

For Continuous Drain: 1. Ensure unit is level. 2. Remove bucket. 3. Attach hose to drain port (ensure tight connection). 4. Route hose to drain location (downward slope required). 5. Replace bucket (unit will not operate without bucket inserted).

Care & Storage

For seasonal storage: 1. Unplug unit. 2. Empty and clean water bucket. 3. Clean air filter and let dry. 4. Coil power cord neatly. 5. Store in cool, dry place in upright position.

CAUTION! Do not store with water in bucket. Protect from dust and extreme temperatures.

Regulatory Information

UL Listed; meets U.S. safety standards. Energy Star certified. This product contains refrigerant R-410A. For disposal, consult local regulations. Copyright © Danby Products Inc. For support, visit www.danby.com or contact 1-800-263-2629.

Troubleshooting

Reset: Unplug for 5 minutes to reset electronic controls.

Service: 1-800-263-2629; www.danby.com